These are leftover from a massive install project. All of these units are new and have never been turned on but several of them have had the outer boxes opened. 100% easiest installations for point to point system i have ever completed as they just work right out of the box.
Iinformation below pulled from manufactures website. LT+ is a high power 25dBm (316mW) outdoor wireless bridge system operating in the 2.4GHz unlicensed frequency spectrum providing real world throughput up to 100 Mb/sec. It complies with the 802.11gn or 802.11an standards to insure interoperability. LT+ creates a transparent wireless bridge between two networks up to 3 miles apart with good line of sight.
It supports VOIP, VPN, multiple MAC addresses and DHCP across the wireless link. It is the perfect plug and play solution for connecting the networks in two or more buildings, internet access sharing, remote video surveillance or remote network access. LT+ units can be connected in a mesh configuration to allow interconnecting more than two sites. With its password verification, MAC address authentication, SSID suppression and advanced WPA encryption, the system provides the best available wireless data security.
Installation is a snap because of the plug and play features which have been built into the system. Just install the antennas and plug in the power inserters. The units will automatically find their peer and create a secure wireless network link.If changes to the pre-configured settings are desired, they can be easily done thru the built-in web interface from any point on either side of the network. There are no drivers or software that needs to be loaded to the computer. LT+ comes complete with all the electronics that are needed for a point to point wireless network bridge installation; including 2 powerful 14dBi 802.11gn or 16dBi 802.11an MIMO antennas with built-in high power electronics, Bracket Kits which accommodate pole or wall mounting, Cat5e rated POE (Power Over Ethernet) power inserters and 24VDC auto-ranging power supplies. Customer needs to supply CAT5 cabling between the power inserter and the antenna and between the power inserter and his computer, router or switch. The EZBR-0516+ management interface is IPv6 enabled, https enabled.
The password can be changed, and there are no rules for password length or content. The item "EZ-Bridge-Lite EZBR-0214+ High Power Outdoor Wireless Point to Point System" is in sale since Thursday, March 11, 2021. This item is in the category "Computers/Tablets & Networking\Home Networking & Connectivity\Wireless Access Points". The seller is "kingnewby" and is located in Tecumseh, Kansas. This item can be shipped to United States.